Here in Germany Pickel-Rick is quite common.
- 0 Posts
- 6 Comments
froh42@lemmy.worldto Technology@lemmy.world•The IRS Tax Filing Software TurboTax Is Trying to Kill Just Got Open SourcedEnglish2·7 days agoYes, I agree, so as Vlad learned even if you leave them on the ground and put tires on them so they don’t fly off, something might come along and successfully migrate around 40 of them to the cloud.
froh42@lemmy.worldto Technology@lemmy.world•The IRS Tax Filing Software TurboTax Is Trying to Kill Just Got Open SourcedEnglish51·7 days agoFor the F35 unfortunately a lot of its capabilities seems to be cloud based. (At least for maintenence, I don’t know of on the air).
That’s why I’m angry my stupid government still has wants to buy the stupid things instead of sitting this generation out and going to an own 6gen aircraft.
If I’m going really fast I may give people who are just sitting on the left lane a single flash when I’m still quite far away so they are aware I’m closing in.
Going fast is only possible on a quite empty road anyways.
With a trailer you’re limited to 80kph (or 100kph im some cases)
And police is setting also setting up “distance traps” on the Autobahn, you can get a ticket (or even lose your license) for tailgating.
Look on github for Rappetor’s SV08 mainline repository. You’ll need a new mmc or sd card (both are ok) and a “five bucks” STLink programmer, but then it is quite easy to put mainline klipper on your sv08. The mainboard is a cb1 clone with the “main” ST microcontroller for driving the steppers on the same board (for cost reduction, probably)
That’s the prerequisite for using a probe. like a btt eddy on a SV08, for example.
Other than the SV08 has a few issues like super noisy board fan which can be very easily be taken care of. (Funnily software control of the fan is possible, but just not done in the default firmware)
My mods are mainline klipper, btt eddy, new (printed) extruder shroud with better airflow, a microswiss hotend and a second camera (USB webcam for second viewing angle and better resolution).
Out of the box the SV08 has a bit of problems keeping a consistent Z offset due to missing temperature calibration for the probe. More reliable solutions (ported from voron) like klicky are available. I chose eddy - but haven’t perfectly tuned it in, either. I’ll try the eddy-ng firmware (github) next week.