Truck has shit the bed.

I needed something that would get me to the next town over every day for work for the next few months.

I’m trying really hard to get out of debt so as much as I wanted to just bite the bullet and get a newer, decent, vehicle I ended up buying a junker.

190k miles. Runs okay. Sounds rough but no knocking or ticking. The exhaust has just been jb welded in a few places (which is probably what that weird smell was). Bearing is going out in one of the pulleys.

Brake pedal sinks pretty low before the brakes start to grab. Is this typical for this model?

Anything I need to look out for?

  • empireOfLove2@lemmy.dbzer0.com
    link
    fedilink
    English
    arrow-up
    18
    arrow-down
    1
    ·
    edit-2
    2 days ago

    All those 2000s Toyotas sound kinda rough tbh. They are chain driven OHC timing sets and out of the 6 or so I’ve seen/worked on, most of them rattle and clank a concerning amount. if youre used to quiet belt driven Hondas or pushrod American engines it takes getting used to.

    Excessive noise at startup usually indicates the timing tensioner is worn though, and may need a camera inspection, so keep an ear out for that.

    For shaking roughness the usual tuneup suspects are first. Spark plugs help, get OEM ngk brand. Fix exhaust leaks at the manifold, and replace the upstream oxygen sensor, this will get the ECU fuelling the engine correctly again. Change the oil, and check it every tank of gas for oil consumption. Put in a couple cans of sea foam at next gas station fill up.

    Definitely check out the ATF and change it if it is automatic. Mid 2000’s Toyota transmissions tend to have issues when neglected and often don’t get the atf changed enough.

    For the brakes, do a visual inspection first. Jack up and remove tires. Check front and back pads/rotors/calipers for leaks, wear level, and uneven wear. Check rear drums (assuming it is a 4cyl model with rear drums) for wheel cylinder fluid leaks inside, worn shoes, or broken hardware.

    Generally, a long travel/mushy pedal is caused by the brake master cylinder wearing out its bore, causing the piston seals to not hold fluid until it’s partially depressed. It also happens if someone has been in there fucking with the brake system and did not properly bleed all the air out, or a caliper/wheel cylinder has failed and is leaking. If visual inspection comes up all OK I would flush the brake system with fresh fluid yourself (ez bleed kit is $10 and lots of guides exist on YouTube etc) and see if performance improves. If not, order a master cylinder from RockAuto.