Hey everyone,

I’m thinking of upgrading from a creality k1 to a snapmaker u1. Partly for the multicolour printing with the toolhead system, but also because of a few frustrations with the k1.

Before I make the jump, Can anyone comment on what the general print quality is like with the U1?

Cheers

  • Starfarer@lemmy.todayOP
    link
    fedilink
    English
    arrow-up
    2
    ·
    7 days ago

    What slicer do you use?

    I normally use orcaslicer but see they have their own fork with some tweaks?

    • csudcy@sh.itjust.works
      link
      fedilink
      English
      arrow-up
      1
      ·
      6 days ago

      Yeah, I use standard Orca as well - wanted to make sure I don’t get rug-pulled if Snapmaker decide to go the Bambu route (which, to be fair to them, I don’t think they are). Disclaimer though, I’m just assuming you need to have an account to use their fork, I haven’t actually tried it - if you try it out, lmk what it’s like 😅