I’m a bit stumped, and am looking for advice. I have an extremely old (Circa 2015) Craftbot Plus. It’s hardly any parts of the original unit, kept alive with custom parts out of just spite. I use cura as my slicer, and it works fine for my needs. Recently, my kids have wanted to print custom keycaps. This is a difficult FDM print to begin with, and my old hardware isn’t doing me any favors; it might be impossible. That being said, my prints turn out good, except for the tiny details in the actual stem. The picture is attached of various settings; I’ve tried a ton of stuff. I can share a cura profile, but the gist is I’m printing in PLA and have experimented with 195-210 degrees, .1mm layer height, line widths between .175-.2mm, various speeds, minimum speed and minimum layer duration, I’ve disabled ironing, and I’ve played with retraction. I’m kind of stumped, and am wondering if anyone has things I should try.

  • ButteredWaffle_@reddthat.com
    link
    fedilink
    English
    arrow-up
    4
    ·
    1 month ago

    Hiya, my 2 cents. If you have a well tuned machine (which i assume you do):

    • Extrusion widths that are up to 50% larger than your nozzle diameter are beneficial, because the brim of your nozzle flattens the material against the lower layer
    • Printing many keycaps at once can help the stem cool completely between layers, if heat is a problem
    • Have you tuned pressure advance after swapping nozzles?
    • IMALlama@lemmy.world
      link
      fedilink
      English
      arrow-up
      3
      ·
      1 month ago

      Extrusion widths that are up to 50% larger than your nozzle diameter are beneficial, because the brim of your nozzle flattens the material against the lower layer

      It always amused me that some slicers that allow for percentage based extrusion widths use layer height, and not nozzle diameter when applying that value…

    • surfrock66@lemmy.worldOP
      link
      fedilink
      English
      arrow-up
      1
      ·
      1 month ago

      I’ve tweaked the line width a lot, going down to .175 but not lower. It didn’t seem to make a difference. I did try to add another junk model next to the caps just to offset the heat; it unfortunately didn’t help. Which settings are you looking at with pressure advance; the main thing I have been touching is flow rate.